When decorating, put to work is the best way to save money. To paint, wallpaper or place your floors do not need more than good advice. No need to call a professional if you do not have money, you yourself can change your story. Today we will like to place in just ten steps.

Materials:

Laminate Flooring
Baseboard moldings
Moldings adaptation and expansion
Solvent-based asphalt waterproofing (1 bucket of 19 liters pays 19 m2)
Under carpet of 1 / 4 "plastic
White glue
Silicone cartridge
Wood screws

Step by step:

1. The first thing you do is vacate the area in which you work.

2. Next, apply the solvent-based asphalt impermeablizante white (preferably) on the floor, which serves to protect your floor from possible moisture and is essential if the placement is done on the ground floor.

3. Place the support under carpet with a spare on each side of 3 CMY is fixed to the walls.

4. To start the next step you should decide which figure you're going to drop, then we recommend the traditional placement, however if you want you can place diagonally, in the form of snail or some other figure that comes to mind. But what you should not lose sight of is that you put the staves so that they do not match the start or the court with terminición a contiguous staves, except that it is the perimeter of the area, as can be seen in the figure below.

5. For placement of the floor, parts of the stave unite with white glue "dovetailing" the songs, leaving a separation of 1.5 cm walls around the perimeter of the floor for the floor work freely with temperature changes. To make the cut in the staves, you can use a jig in the absence of a hacksaw.

6. The perimeter to leave withthe separation wall is covered with a mold called Zocalo, which you can stick with silicone or screwed to the walls. is recommended that it be the same color of the floor.

7. The next step is to cut the doors that open toward the floor, where it will be placed, and this is necessary, because the ground rises from 1 to 1.5 cm.

8. At the joints of the floor with other floors, moldings are placed according to the case. For example, with floors at different levels, are used to finish adjusting trim. With floors at the same level of expansion moldings are used, without forgetting that these frames should also be the same color of the floor.

9. Ready for you to leave the floor, you should clean with a damp cloth to remove stains caused by excess glue.

10. Finally, you must rearrange the furniture, they avoid being dragged to avoid scratching or abusing the floor.

Via | Makerwiki

Incoming search terms:

• renew parquet
• renew parquet flooring
• how to renew parquet flooring
• דמוי פרקט בבית
• Renewing parquet floors

DIY, Flat, tips